Weslo Cadence Ex 18 User Manual download pdf (Page 5)

16 5

Thank you for selecting the WESLO CADENCE

treadmill. The CADENCE 60 treadmill combines ad-

vanced technology with innovative design to let you

enjoy an excellent form of cardiovascular exercise in

the convenience and privacy of your home. And when

you’re not exercising, the unique CADENCE 60 tread-

mill can be folded up, requiring less than half the floor

space of other treadmills.

For your benefit, read this manual carefully before

using the treadmill. If you have questions after read-

ing this manual, please call our Customer Service

Department at 08457 089 009. To help us assist you,

please note the product model number and serial num-

ber before calling. The model number of the treadmill

is WETL15131. The serial number can be found on a

decal attached to the treadmill (see the front cover of

this manual for the location of the decal).

Before reading further, please review the drawing

below and familiarise yourself with the labelled parts.

BEFORE YOU BEGIN

Handrail

Console

Key/Clip

Circuit Breaker

Incline Leg

Walking Belt

Hood

Front Wheel

Foot Pad

Rear Roller

Adjustment Bolts

Water Bottle Holder

(Bottle not included)

Storage Latch

RIGHT SIDE

LEFT SIDE

MAINTENANCE AND TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and

follow the steps listed. If further assistance is needed, please call our Customer Service Department.

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a properly earthed outlet. (See page 10.) If an ex-

tension cord is needed, use only a 3-conductor, 1mm

(14-gauge) cord that is no longer than 1.5 m

(5 ft.). IMPORTANT: The treadmill is not compatible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.

c. Check the circuit breaker located on the treadmill

near the power cord. If the switch protrudes as

shown, the circuit breaker has tripped. To reset the

circuit breaker, wait for five minutes and then press

the switch back in.

PROBLEM: The power turns off during use

SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see c. above). If the

circuit breaker has tripped, wait for five minutes and then press the switch back in.

b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for

five minutes, and then plug it back in.

c. Remove the key from the console. Reinsert the key fully into the console.

d. If the treadmill still will not run, please call our Customer Service Department.

PROBLEM: The displays of the console do not function properly

SOLUTION: a. Remove the key from the console and UNPLUG THE POWER CORD. Remove the screws from

the hood, and carefully remove the hood.

Locate the Reed Switch (46) and the Magnet (49) on

the left side of the Pulley (53). Turn the Pulley until the

Magnet is aligned with the Reed Switch. Make sure

that the gap between the Magnet and the Reed

Switch is about 3 mm (1/8 in.). If necessary, loosen

the Screw (26) and move the Reed Switch slightly.

Retighten the Screw. Re-attach the hood, and run the

treadmill for a few minutes to check for a correct

speed reading.

Tri

Reset

Tripped Reset

Top View

3 mm

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Weslo Cadence Ex 18 User Manual Page 5

Comments to this Manuals

Related products and manuals for Treadmills Weslo Cadence Ex 18