Weslo WLTL29306.0 User Manual download pdf (Page 9)

8. Carefully lower the Left and Right Handrails (22,

33) until they are touching the floor.

See the lower drawing. Position the Uprights (53,

54) so that the treadmill Frame (51) is centered

between the Uprights.

Firmly tighten the four Handrail Bolts (2) and the

two Frame Pivot Bolts (1) used in steps 1 and 3.

Be careful not to overtighten the Frame Pivot

Bolts,

Top View o o

9. Attachthe Latch Housing (48) to the Left Upright

(53) with two Latch Screws (7); start both Latch

Screws before tightening them. Make sure

that the large hole in the Latch Housing is on

the indicated side,

Remove the knob from the pin. Make sure that

the collar and the spring are on the pin. (Note: If

there are two collars, place one on each side of

the spring.) Insert the pin intothe Latch Housing

(48). Then, tighten the knob onto the pin. Larg

10. Raise the Frame (51) to the storage position

(see HOW TO FOLD THE TREADMILL FOR

STORAGE on page 13). Attach an Incline Leg

(69) to the Frame (51) with an Incline Leg Bolt

(32), two Incline Leg Washers (43), and an

Incline Leg Nut (46) as shown.

Repeat this step on the other side of the

Frame (51),

Adjust the Incline Legs (69) to the desired level

(see HOW TO CHANGE THE INCLINE OF THE

TREADMILL on page 12).

11. Make sure that ell parts are properly tightened before you use the treadmill. Keep the included hex key

in a secure place. The hex key is used to adjust the walking belt (see page 16). To protect the floor or carpet,

place a mat under the treadmill.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 22 23

No comments

Weslo WLTL29306.0 User Manual Page 9