Weslo WLEL31216 Owner's Manual download pdf (Page 18)

MAINTENANCE

Regular maintenance is important for optimal

performance and to reduce wear. Inspect and properly

tighten all parts each time the stepper climber is used.

Replace any worn parts immediately.

To clean the stepper climber, use a damp cloth and a

small amount of mild soap. IMPORTANT: To avoid

damage to the console, keep liquids away from

the console and keep the console out of direct

sunlight.

CONSOLE TROUBLESHOOTING

Most console problems are the result of low

batteries; for replacement instructions, see assembly

step 12 on page 13.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback when

the pedals move in detectable steps, the reed switch

should be adjusted.

Note: The console will provide exercise feedback when

the pedals move upward and downward in detectable

steps. When the pedals do not move or when the ped-

als move only in small steps near the top or near the

bottom of the base, the console will not provide exer-

cise feedback.

First, remove the M4 x 10mm Screw (67) and the Base

Leg Cover (23) from the front of the Base Leg (10).

Next, insert your finger into the opening and slide

the Reed Switch (83) slightly toward or away from

the Magnet (71). Then, move the pedals upward and

downward so that the Magnet passes the Reed Switch

repeatedly. Repeat these actions until the console

displays correct feedback.

When the Reed Switch (83) is correctly adjusted,

reattach the Base Leg Cover (23).

MAINTENANCE AND TROUBLESHOOTING

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Weslo WLEL31216 Owner's Manual Page 18