Weslo TREADMILL 831.297100 User Manual Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 23
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
3. Have a second person lift and hold the front end
of the Frame (51). Hold a Frame Spacer (11) be-
t
ween the Right Handrail (54) and the Frame.
Attach the Right Handrail to the Frame with a
F
rame Pivot Bolt (1), a Frame Washer (14), and a
Handrail Star Washer (9). Do not tighten the
Frame Pivot Bolts yet.
Repeat this step on the left side of the tread-
mill.
3
7
51
1
54
1
1
14
9
4. Hold the Console Assembly (91) near the Right
Handrail (54).
Touch the Right Handrail to dis-
charge any static.
Next, remove the wire from the end of the Wire
Harness (98). Insert the end of the Wire Harness
through the two looped plastic ties.
Then, press the end of the Wire Harness (98) into
the connector on the back of the Console
Assembly (91) in the location shown. The end of
the Wire Harness should slide easily into the
connector and snap into place. If it does not,
turn the end of the Wire Harness and then try
again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE
DAMAGED WHEN THE POWER IS TURNED
ON.
4
5. Set the Console Assembly (91) on the Right
Handrail (54) and the Left Handrail (not shown).
Partially tighten two Crossbar Screws (5) with two
Crossbar Star Washers (12) (only one of each is
shown) into the Handrails and the Console
Assembly. Then, partially tighten four Console
Screws (7) (only two are shown) into the
Handrails and the Console Assembly. Then,
tighten all six Screws.
Insert the excess Wire Harness (98) down into
the Right Handrail (54). Tighten the two plastic
ties around the Wire Harness, and then cut off the
ends of the plastic ties.
5
Plastic
Ties
Connector
91
54
98
91
98
54
7
7
12
5
Plastic
Ties
98
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 22 23

Comments to this Manuals

No comments