Weslo AerobicStride WLTL 13921 User Manual download pdf (Page 4)

ASSEMBLY

The help of a second person is recommended. Set the treadmill in a cleared area and remove all packing

materials. Do not dispose of the packing materials until assembly is completed. Assembly requires a phillips

screwdriver and an adjustable wrench (not included).

1. Slide the Handrail (6) onto the four welded bolts in the

Base (19) as shown.

See the inset drawing. Attach each side of the Handrail

(6) to the Base (19) with two M8 Nylon Nuts (16).

2. Lift the front of the Frame (32, 35) and align the holes

near the front of the Frame with one of the three sets of

holes in the Handrail (6). Insert the two Long Pins (5)

into the Handrail and the Frame. Make sure that the

Long Pins are fully inserted at the same level.

See the inset drawing. Insert a Cotter Pin (8) into the

hole near the end of each Long Pin (5). Make sure that

the Cotter Pins are fully inserted.

Attach the Console Plate (2) to the Handrail (6) with two

M4 x 16mm Screws (3) as shown. Feed the Reed

Switch Wire (7) up through the indicated hole in the

Console Plate.

Hold the Console (1) near the Console Plate (2). Plug

the Reed Switch W

ire (7) into the back of the Console.

Feed the excess Reed Switch W

ire down through the

hole in the Console Plate. Attach the Console to the

Console Plate with four M4 x 16mm Screws (3).

careful not to pinch the Reed Switch W

ire.

Bolts

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Weslo AerobicStride WLTL 13921 User Manual Page 4