Weslo Cadence 830 User Manual download pdf (Page 3)

14. Never start the treadmill whilst you are

standing on the walking belt. Always hold the

handrails whilst using the treadmill.

15. The treadmill is capable of high speeds.

Adjust the speed in small increments to

avoid sudden jumps in speed.

16. The pulse sensor is not a medical device.

Various factors, including the user's move-

ment, may affect the accuracy of heart rate

readings. The pulse sensor is intended only

as an exercise aid in determining heart rate

trends in general.

17. Never leave the treadmill unattended whilst it

is running. Always remove the key and

unplug the power cord when the treadmill is

not in use.

18. Do not attempt to raise, lower, or move the

treadmill until it is properly assembled. (See

ASSEMBLY on page 5, and HOW TO FOLD

AND MOVE THE TREADMILL on page 11.) You

must be able to safely lift 20 kg (45 lbs.) in

order to raise, lower, or move the treadmill.

19. Do not change the incline of the treadmill by

placing objects under the treadmill.

20. When folding or moving the treadmill, make

sure that the storage latch is fully closed.

21. Inspect and tighten all parts of the treadmill

every three months.

22. Never insert or drop any object into any

opening.

23. The roller guards must be 3 mm (1/8 in.) from

the rear roller (see the drawing on page 4).

Remove the key and adjust the roller guards,

if necessary.

24.

DANGER: Always unplug the power

cord immediately after use, before cleaning

the treadmill, and before performing the

maintenance and adjustment procedures

described in this manual. Never remove the

motor hood unless instructed to do so by an

authorised service representative. Servicing

other than the procedures in this manual

should be performed by an authorised ser-

vice representative only.

25. This treadmill is intended for in-home use

only. Do not use this treadmill in any com-

mercial, rental, or institutional setting.

WARNING:

Before beginning this or any exercise program, consult your physician.

This is especially important for persons over the age of 35 or persons with pre-existing health prob-

lems. Read all instructions before using. ICON assumes no responsibility for personal injury or prop-

erty damage sustained by or through the use of this product.

SAVE THESE INSTRUCTIONS

The decal shown below has been placed on your treadmill. If

the decal is missing or illegible, please call our Customer

Service Department, toll-free, to order a free replacement

decal (see ORDERING REPLACEMENT PARTS on the back

cover of this manual). Apply the decal in the location shown.

Note: This decal is shown at 38% of actual size.

PROBLEM: The walking belt is off-centre or slips when walked on

SOLUTION: a. If the walking belt is off-centre, first remove the key

and UNPLUG THE POWER CORD. If the walking

belt has shifted to the left, use the allen wrench to

turn the left rear roller bolt clockwise 1/2 of a turn; if

the walking belt has shifted to the right, turn the

bolt counterclockwise 1/2 of a turn. Be careful not to

overtighten the walking belt. Plug in the power cord,

insert the key and run the treadmill for a few minutes.

Repeat until the walking belt is centred.

b. If the walking belt slips when walked on, first remove

the key and UNPLUG THE POWER CORD. Using

the allen wrench, turn both rear roller bolts clockwise,

1/4 of a turn. When the walking belt is correctly tight-

ened, you should be able to lift each side of the walk-

ing belt 7 to 10 cm (3 to 4 in.) off the walking plat-

form. Be careful to keep the walking belt centred.

Plug in the power cord, insert the key and carefully

walk on the treadmill for a few minutes. Repeat until

the walking belt is properly tightened.

PROBLEM: The walking belt slows when walked on

SOLUTION: a. If an extension cord is needed, use only a 3-conductor, 1 mm

(14-gauge) cord that is no longer

than 1.5 m (5 ft.).

b. If the walking belt is overtightened, treadmill perfor-

mance may decrease and the walking belt may be

permanently damaged. Remove the key and

UNPLUG THE POWER CORD. Using the allen

wrench, turn both rear roller adjustment bolts coun-

terclockwise, 1/4 of a turn. When the walking belt is

properly tightened, you should be able to lift each

side of the walking belt 7 to 10 cm (3 to 4 in.) off the

walking platform. Be careful to keep the walking belt

centred. Plug in the power cord, insert the key and

run the treadmill for a few minutes. Repeat until the

walking belt is properly tightened.

c. If the walking belt still slows when walked on, call our Customer Service Department.

Rear Roller

Adjustment Bolts

7–10 cm

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Weslo Cadence 830 User Manual Page 3

Comments to this Manuals

Related products and manuals for Treadmills Weslo Cadence 830