Weslo Gym 750 User Manual

USER'S MANUALCAUTIONRead all precautions and instruc-tions in this manual before usingthis equipment. Save this manualfor future reference.Model

1119. Apply grease to an M10 x 78mm Bolt (54). Attachthe Pulley Arm (38) to the Upright (3) with the Boltand an M10 Nylon Locknut (68). Do not over-ti

M6 Washer (73)M8 Washer (71)M8 Nylon Locknut (69)M10 Washer (70)M10 Nylon Locknut (68)M6 Nylon Locknut (72)M4 Washer (77)M10 x 125mm Bolt (64)M10 x 15

323133329452469716881921212122222245404068572122244856574263434343536373735507055687052536868433534354752696871354235343435356868535344443534353534356

WARNING DECAL PLACEMENT192WESLO is a registered trademark of ICON IP, Inc.WARNING DECAL PLACEMENT . . . . . . . . . . . . . . . . . . . . . . . . . .

TROUBLESHOOTING AND MAINTENANCE18TIGHTENING THE CABLESWoven cable, the type of cable used on the weightsystem, can stretch slightly when it is first u

The cable diagrams below show the proper routing of the Short Cable (47), the Low Cable (48), the Press Cable(49), and the High Cable (50). Use the di

16 5Before beginning assembly, carefully read thefollowing information and instructions:•Assembly requires two people.• Place all parts in a cleared a

15This section explains how to adjust the weight system. Refer to the accompanying exercise guide to see the cor-rect form for each exercise. Make sur

33. Make sure that all parts have been properly tightened. The use of all remaining parts will be explained inADJUSTMENTS, on the next page. Before us

1327. Route the Low Cable (48) over a 90mm Pulley(34). Attach the Pulley, a Cable Trap (36), andtwo Finger Guards (35) to the lower set of holesin the

1223. Attach the end of the Short Cable (47) to the “U”-bracket (43) with an M8 Washer (71) and an M8Nylon Locknut (69). Note: Do not completelytighte