Weslo TREADMILL 831.297100 User Manual download pdf (Page 6)

ASSEMBLY

ssembly requires two persons.

et the treadmill in a cleared area and remove all packing materials;

o not

dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking

belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to

the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant

on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

In addition to the included hex key , assembly requires a phillips screwdriver , a

spanner , and wire cutters .

Note: To identify small parts during assembly, see the PART IDENTIFICATION CHART in the center of this

manual. Some parts may be preassembled.

1. Make sure that the power cord is unplugged.

Have a second person hold the Base (52) in the

position shown.

Identify the Right Handrail (54), which has a large

hole near the lower end.

Hold the Right Handrail

so the bend is in the position shown. Attach

the Right Handrail to the Base (52) with two

Handrail Bolts (2), two Handrail Washers (14) and

two Nuts (16). Do not tighten the Handrail Bolts

yet.

Attach the Left Handrail (53) to the Base (52)

in the same way.

Large

Hole

Bend

2. With the help of a second person, raise the

Handrails (53, 54) so the Base (52) is flat on the

floor as shown.

Position the front end of the treadmill Frame (51)

between the Handrails (53, 54) as shown. Next,

locate the long wire inside the lower end of the

Right Handrail (see the inset drawing). Securely

tie the end of the wire to the end of the Wire

Harness (98).

Then, pull the opposite end of the wire until the

Wire Harness (98) is extending from the upper

end of the Right Handrail (54).

Wire

1 2 3 4 5 6 7 8 9 10 11 ... 22 23

No comments

Weslo TREADMILL 831.297100 User Manual Page 6